Skip to content
GableGreens

Home Improvement

How Deep Should Fence Posts Be?

Bury one third to one half of the fence height: 2 to 3 feet (60 to 90 cm) for a 6 foot fence. Includes hole width, frost depth and concrete per post.

Save to Pinterest (opens Pinterest in a new tab)

Illustration of a cross-section of a fence post set deep in the ground on gravel, with a ruler and post hole digger

Skip the arithmetic. Enter your measurements and get quantities in imperial or metric units.

Open the Fence Calculator

Set fence posts so that one third to one half of the above-ground height is in the ground. For a 6 foot (1.8 m) fence, that means a hole 2 to 3 feet (60 to 90 cm) deep.

Post depth by fence height

Fence height Hole depth Post length to buy
3 ft (0.9 m) 18–24 in (45–60 cm) 5 ft (1.5 m)
4 ft (1.2 m) 24 in (60 cm) 6 ft (1.8 m)
6 ft (1.8 m) 24–36 in (60–90 cm) 8–9 ft (2.4–2.7 m)

Go to the deeper end for solid privacy fences, exposed and windy sites, sandy or loose soil, and gate posts, which carry a swinging load.

Frost depth

Where the ground freezes, the bottom of the footing must sit below the frost line, or frost will lift the post a little each winter. Frost depth varies widely by region. Your local building office can give the figure, and it overrides the one-third rule when it is deeper.

Hole width

Dig the hole about three times the width of the post.

  • A 4×4 post (3.5 in actual) needs a hole 10 to 12 in across.
  • A 100 mm post needs a hole about 300 mm across.

A hole that is wider at the bottom than the top resists being pulled up by frost.

Gravel at the bottom

Put 4 to 6 inches (10 to 15 cm) of gravel in the bottom of the hole before the post goes in. It lets water drain away from the end grain, which is where timber posts rot first. Dig the hole deeper by that amount.

Concrete or not

  • Concrete gives the firmest hold and is the usual choice for privacy fences and gate posts. Slope the top away from the post so water runs off.
  • Compacted gravel drains better and makes posts easier to replace. It suits lighter fences in firm soil.

How much concrete per post

A 10 in wide, 24 in deep hole with a 4×4 post takes about 0.9 cubic feet of concrete, which is three 50 lb bags or two 80 lb bags. A 300 mm wide, 600 mm deep hole with a 100 mm post takes about 36 litres, around four 20 kg bags. Fast-setting post mixes have their own yield per bag, so follow the bag.

Count the materials

Use the fence calculator for the number of posts, pickets and rails in your run. Then put the post count and hole size into the concrete calculator, in post hole mode, for the bags.

Skip the arithmetic. Enter your measurements and get quantities in imperial or metric units.

Open the Fence Calculator

Monthly home energy tips

One email a month with our new guides, a free calculator to try and the latest electricity prices. Unsubscribe any time.

The signup form is provided by Hostinger Reach and loads when you click. You confirm by email before you get anything. Privacy policy.

Founder and editor, GableGreens

Muslam Uddin founded GableGreens to put plain answers and the working behind them in one place. Every guide is researched from government agencies, standards bodies and manufacturer documents, and the sums are checked before it is published. The guides are not professional advice: where a job needs a licensed electrician or engineer, the guide says so. How we research and write.